Crankshaft in place
Viewed: 2310 times.
|
Main caps torqued up, and it rotates freely :)
Viewed: 2842 times.
|
Started modifyiung the end-flange of the exhaust manifold. The standard flange would get too close to the firewall, as the XU10 block is like 15mm taller than the XU9 which the manifold is made for.
Viewed: 2566 times.
|
Homemade downpipe with flexi-pipe to absorb some vibrations
Viewed: 2543 times.
|
Attached the 2.5" v-band flange to manifold collector with a few spot welds.
Viewed: 2482 times.
|
V-band on downpipe
Viewed: 2337 times.
|
Picture into the collector, not the best design, but hopefully it'll do it's job.
Viewed: 2191 times.
|
Pistons are now in the block!
Viewed: 2402 times.
|
Looks pretty nice
Viewed: 2237 times.
|
Shiny ;)
Viewed: 2965 times.
|
Back to the crankshaft, time to put on the oil-pump.
Viewed: 2389 times.
|
Just another angle
Viewed: 2218 times.
|
Oil-pump on
Viewed: 2336 times.
|
Another angle
Viewed: 2312 times.
|
Mounted the Mocal oil-cooler sandwich plate
Viewed: 2423 times.
|
Now it's ready to have the sump fitted, which I don't have any pictures of, guess you can imagine how that's done :)
Viewed: 2896 times.
|
Cometic 3-layer stainless-steel headgasket
Viewed: 2442 times.
|
1.3mm thick, 88mm bore so I had to grind it out a little to 88.5mm because my pistons sits 0.3mm over deck @TDC.
Viewed: 2428 times.
|
Engine mounted in car, and ready to be started for the first time :)
Viewed: 3698 times.
|
Catcams parts arrived :)
Viewed: 2581 times.
|
4
