It's a Mitsubishi TD04-13T unit off a Subaru Impreza WRX, in very good condition. Thanks Rudy!
Viewed: 5135 times.
|
A close-up of compressor inlet propeller.
Viewed: 2181 times.
|
And a close-up of the model and serial no.
Viewed: 2087 times.
|
Flipped on it's back :-).
Viewed: 2133 times.
|
Manifold flange.
Viewed: 2151 times.
|
Wastegate actuator.
Viewed: 2122 times.
|
Turbine propeller, wastegate and downpipe flange.
Viewed: 2265 times.
|
Oil inlet for bearings lubrication.
Viewed: 2024 times.
|
A custom braided oil hose for the same use.
Viewed: 2086 times.
|
A custom T-split take off for the pressurised oil.
Viewed: 2004 times.
|
No better place for it than at the front of the block where the oil pressure sensor is screwed in :-).
Viewed: 1992 times.
|
A custom hose fitting for the oil return to the sump.
Viewed: 2065 times.
|
There's a very convenient place for it too - at the back of the block instead of (unused) oil level sensor :-).
Viewed: 1986 times.
|
Some Y-splitters for the fuel lines, which may or may not get used later on.
Viewed: 2066 times.
|
And finally... a -1 to 2.5 bars Racetech boost gauge, previously used on a Sierra Cosworth.
Viewed: 2504 times.
|
Also may or may not get used later on during the build.
Viewed: 2222 times.
|
2
