We'll have to extend the rod in the cylinder, to get the full travel.
Viewed: 3471 times.
|
Copper pipes made and everything connected up. Note: this is plumbed in WRONG (in and out swapped), but it has been corrected, i just haven't taken a pic since.
Viewed: 3799 times.
|
With the dual clutch and dual throttle controls as well as brakes sorted, it was time to tackle the dual gear-shift system.
Viewed: 4202 times.
|
I still can't get over how the car looks interesting, cool and "phat" with the rear engine in :-D.
Viewed: 3679 times.
|
Some gear-shift bits trial fitted & diagram from Peugeot Spare Parts CD ready ;-).
Viewed: 3511 times.
|
But it turned out that the diagram has had a big error - if you're familiar with the gear-shift system, you'll spot it! Very surprising.
Viewed: 3640 times.
|
It was now time to get on with the actual work.
Viewed: 3559 times.
|
Everything disassembled and gearstick taken out.
Viewed: 3206 times.
|
My father chopping the gearstick end off of the spare "rotating" rod.
Viewed: 2917 times.
|
With the help of the hydraulics man, the gearstick end is spot-welded onto a piece of steel.
Viewed: 2893 times.
|
Action shot... definately not as dangerous as it looks in the pic!
Viewed: 2842 times.
|
And then my father proceeded with welding the two bits together properly.
Viewed: 2830 times.
|
Nice arty shot.
Viewed: 2810 times.
|
A little bit of welding from another angle...
Viewed: 2964 times.
|
...and again a (closeup) arty shot.
Viewed: 2725 times.
|
Gearstick end awaiting a rod to be welded on the steel plate...
Viewed: 2768 times.
|
3
