The windscreen had a chip in it, so inevitably cracked when I took it out :-(
Viewed: 1315 times.
|
A bit of surface rust was found once the 'screen was out.
Viewed: 1232 times.
|
Rust-be-gone.
Stripped, treated and primed
Viewed: 1245 times.
|
I think the interior will need a good clean when I'm finished!
Viewed: 1227 times.
|
Welds being reinforced at the bottom of the nearside B post.
Viewed: 1359 times.
|
The same area on the offside
Viewed: 1229 times.
|
With the welding done, I stripped the old cracked sealer out of the joint between the quarter panel and nearside sill.
Viewed: 1199 times.
|
Old sealer stripped out of the top of the B post, and the seam above the rear side windows
Viewed: 1231 times.
|
A skim of filler was used to smooth things out after the welding.
Viewed: 1288 times.
|
Then those areas were primed up.
Viewed: 1249 times.
|
Another primer shot
Viewed: 1255 times.
|
And the offside B post primed up
Viewed: 1234 times.
|
I made sure the sill seam was protected with primer before resealing
Viewed: 1256 times.
|
PU sealer was used to seal up the seam.
Viewed: 1314 times.
|
Me sealing up the top seam.
Viewed: 1262 times.
|
Attention to detail, smoothing out the sealer
Viewed: 1329 times.
|
3
